Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/31/2006 9:49:26 AM EST
Posted this elsewhere, thought I would try it here as well:

I have a 20" Colt bbl (A1) that I want to cut down to a 16", open the gas port, and install the Vortex fh.

I know the Vortex will work fine with the thinner profile of the A1 vs A2, just needed some confirmation.

I am looking around for a used Vortex since I am going to Krylon the project.


Anyone see any forseeable problems with this plan?



ETA: Thanks for reading and any replies/suggestions!
Link Posted: 1/31/2006 10:56:52 AM EST
the vortex will fit perfect!


i have a couple of pencil bbl.s that i cut down and installed flashhiders on and the only problem i ran into was with the regular split washers, they tend to ride over the short shoulder of a cut down pencil bbl. but instead i used crush washers that fit on the shoulder fine. with the vortex you will not need a washer if the threads arent long so it should shoulder up fine.

Link Posted: 1/31/2006 5:03:24 PM EST
IM Randall_Rausch on the board or visit his web site and drop him an email.
www.ar15barrels.com/
Link Posted: 1/31/2006 8:30:34 PM EST
i hate mirror threads



adcofirearms and nfa_investments have both done superlight barrels for me with no problems
Link Posted: 2/9/2006 4:24:18 PM EST
the threading...is this a gunsmith job or a machinists job? I have a frankenproject churning in my sick little mind
Link Posted: 2/10/2006 8:57:03 AM EST
Link Posted: 2/10/2006 9:23:23 AM EST
clean job Randall
Top Top