Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
Member Login

Posted: 3/7/2015 6:19:56 PM EDT
I have always used adco barrels and thought I would give Spikes a try. I normally run my 9mm ar platforms suppressed but sometimes do not and I utilize a thread protector, etc.. when doing so.

On all my adco barrels, I get a flush mount with my fixed barrel mount for the octane, I get a flush mount with any attachement.

On this barrel I am not. I dont seem to get a snug stopping point?

I cant imagine it needing a crush washer or spacer, its only 5.5 inches. Thoughts? Should I return or is this normal



Link Posted: 3/7/2015 6:31:42 PM EDT
Crappy threading with no thread relief. At best use shims made for suppressors to make it work, do not use a crush or peel washer.  I'd send it back if I was going to use it with a suppressor.
Link Posted: 3/7/2015 6:34:34 PM EDT
Return it and get a ADCO or TROS barrel.  There's nothing worse than having to "make" something work after you buy it.
Link Posted: 3/7/2015 9:14:51 PM EDT
Discussion ForumsJump to Quoted PostQuote History
Quoted:
Return it and get a ADCO or TROS barrel.  There's nothing worse than having to "make" something work after you buy it.
View Quote



bingo
Top Top