Hello, does anybody know the size of the two roll pins on the sling swivel? Also, are these painted bakelite?

Kinda sorta like bakelite but different.

Resin impregnated stuff sort of like fiberglass.

Wear breathing protection when sanding because the older stuff may have bad juju.

What color is yours painted? Green or black? (Or I think I remember there was a green over black)

The smart guys will be along shortly to correct me and they will have the roll pin size too but I do know it's not quite bakelite.

I think it's the same as the roll pin for the trigger guard.

Here 'ya go.

A1 Rear Sight Wheel Retaining Pin..................1/16x1/4
Trigger Guard Detent Pin..................................1/16x1/4
Forward Assist Pawl Pin(round)......................1/16x1/4
Forward Assist Pawl Pin(teardrop)..................1/16x5/16
Ejector Pin.........................................................1/16x3/8
Gas Tube Pin.....................................................5/64x5/16
Charging Handle Latch pin..............................5/64x5/16
Bolt Catch Retaining Pin..................................3/32x1/2
Forward Assist Pawl Pin..................................3/32x1/2
Forward Assist Retaining Pin..........................3/32x5/8
Type D Stock Swivel Retaining Pin.................1/8x7/16
Front Sling Swivel Pin......................................1/8x1/2
Trigger Guard Pivot Pin....................................1/8x5/8
Rifle Buffer Pad Retaining Pin..........................1/8x3/4
Type D Stock Swivel Bracket Retaining Pin....1/8x7/8

Thanks guys!