Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/24/2017 4:44:23 PM
11/22/2017 10:05:29 PM
Posted: 10/8/2004 4:15:43 PM EST
[Last Edit: 10/8/2004 4:17:07 PM EST by WaWaTuSi]
My trijicon front sight post cracked and left the bottom half in the hole....


My question is...

Is the front sight reverse threaded or normal threaded (i.e. righty tighty lefty loosy). It looks like it may be reversed threaded as the "up" arrow is pointing in the "tightening" direction of a normal threaded screw. I am having trouble removing the bottom half of the sight and want to make sure I am tourquing it the right way.


Also if anyone has any ideas on how to remove this bottom half let me know.


Thanks!


Link Posted: 10/8/2004 4:32:48 PM EST
The tritium post I had was properly threaded. I doubt that yours would be backwards.
Link Posted: 10/8/2004 4:36:22 PM EST
SO I need to crank it "lefty loosey"?

The "up -->" (as would suggest the direction to extract it) points in the opposite direction.....
Link Posted: 10/8/2004 4:38:45 PM EST
You want to twist in the direction of the up arrow.
Link Posted: 10/8/2004 4:39:20 PM EST
Come to think of it, up may be clockwise, which would seem backwards, but be perfectly normal in this application.
Link Posted: 10/9/2004 10:57:09 PM EST
Link Posted: 10/9/2004 10:59:03 PM EST
Do you glow in the dark now?
Link Posted: 10/10/2004 8:02:02 AM EST

Originally Posted By WaWaTuSi:
The "up -->" (as would suggest the direction to extract it) points in the opposite direction.....



Going in the direction of the arrow lowers the post in the sight tower. By lowering the post, the sights look lower, which is the same as raising the shot in regards to the were the rifle is aiming. The arrow is used to sight the rifle in.


Counter-clock wise will remove the post from the FSB.
Top Top