Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 10/4/2005 12:11:05 PM EDT
Can anyone help me with a problem I recently encountered. The trigger pin keep sliding out of the receiver (pictured) after about every 30 shots or so. The pin doesn't seem to be snug and I can push it with my finger nail. This is a brand new trigger kit I just installed. Also, after everyshot, the trigger would stick and then pop back for the next shot. Thanks in advance for the help.

http://img.photobucket.com/albums/0903/24601/IMG_1395.jpg
Link Posted: 10/4/2005 12:15:05 PM EDT
Link Posted: 10/4/2005 12:20:36 PM EDT
Spring legs are probably under the pin, allowing it to slide out.

(the groove in the pin is for the spring to rest on)
Link Posted: 10/4/2005 12:24:13 PM EDT
Man you guys are fast! Thanks for the quick response! I'll double check it tonight, that may be the problem.

Thanks again!
Link Posted: 10/4/2005 12:55:01 PM EDT

Originally Posted By mfingar:
Spring legs are probably under the pin, allowing it to slide out.

(the groove in the pin is for the spring to rest on)



+1
Link Posted: 10/4/2005 1:05:17 PM EDT
The trigger pin is in backwards. The groove goes to the left as when looking at it from the rear of the rifle.
Link Posted: 10/4/2005 1:31:34 PM EDT

Originally Posted By RJK:
The trigger pin is in backwards. The groove goes to the left as when looking at it from the rear of the rifle.



There is no "backwards" when it comes to hammer or trigger pin installation. The groove can be on either side of the lower.
Link Posted: 10/4/2005 1:52:23 PM EDT
Link Posted: 10/4/2005 2:47:02 PM EDT
Top Top