Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 8/22/2004 9:03:36 AM EDT
I just installed both and the FG is a bit loose with side to side & frt to bk play. The twin latches do not fully engage the rail notches (sits about halfway) Any one else with the same problem?
Link Posted: 8/23/2004 7:27:42 AM EDT
[Last Edit: 8/23/2004 7:27:54 AM EDT by C4iGrant]
Link Posted: 8/23/2004 3:00:33 PM EDT
Same problem on my KAC MRE. I slipped two small wire ties under it to act as a shim - so far, so good.
Link Posted: 8/23/2004 3:25:12 PM EDT
My TD Vert Grip is damn tight on the TD Sir rail I have. It took a little effort to get it on the first time. And the tabs didn't go all the way up on one of the levers. As I sit here now its that way, but shows no signs of moving. I've shot it this way and haven't had any problems. I think its just the extremely close tolerances.


-Hershey
Link Posted: 8/24/2004 9:18:24 AM EDT
My TG vertical grip is noticeably loose on one KAC RAS, but tight on the other. Go figure. It isn't going anywhere, but I don't like the slop.
Link Posted: 8/24/2004 10:05:30 AM EDT
I have an early production SureFire M73, and my TD vert is rock solid!..
Link Posted: 8/24/2004 10:21:30 AM EDT
[Last Edit: 8/24/2004 10:21:44 AM EDT by C4iGrant]
Link Posted: 8/27/2004 9:33:32 PM EDT
I wrote to both TD & SF and I have decided to live my M73 b/c even if I send it in, there's no gaurantee that the replacement M73 is any better than the one I have. I filed off abit of the "flash" on two of the ladders and put a strip of blk electrical tape on one side of the TD inner rail and it tightened it up abit.

I will buy a Larue for the next build
Link Posted: 8/30/2004 9:40:42 AM EDT
pittwm

LaRue is a great choice!
Link Posted: 8/30/2004 2:52:36 PM EDT
I have three M73's and have used two different TD grips on them and they are solid. They are more comfortable for my hand than the KAC grips I used to have too. Works for me.
Top Top