Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 6/5/2008 12:43:38 PM EST
I had problems with my first build because the take down pin detent hole was either fouled or not cut deep enough. It was suggested that I clean the hole out with a drill bit instead of cutting a few turns off the spring.

What size is the hole?
Link Posted: 6/5/2008 3:24:58 PM EST
According to the blueprint I have, it should be .093 +/- .004
Link Posted: 6/5/2008 6:26:28 PM EST
If my math is not wrong that would mean about 3/32".

Any idea of the drill number?
Link Posted: 6/5/2008 7:11:11 PM EST
I believe that a #42 drill bit should work. It is .0935
Top Top