Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 8/31/2004 11:52:46 AM EST
So I just picked up a RRA A2 20" post-ban (thanks Equipment Exchange), and was talking to my local dealer about adding an A2 Flash Hider, and Front Sight Assembly with Bayonet Lug once the AWB passes into the sunset.

From what he mentioned, threading the barrel for the FH is no problem, but the FSA would take some work due to the holes lining up differently....anyway, he said he would do it, and it wouldn't cost that much.

So I called RRA to order an A2 FH, Crush Washer, and pre-ban Front Sight Assembly and asked the guy who answered the phone about switching out the FSH for one with a bayonet lug....He made it sound like it was next to impossible to accomplish...

What do you folks think ? Any personal/gunsmithing experience with this ?

Thanks
Link Posted: 8/31/2004 12:14:21 PM EST
If you dealer/gunsmith has machining equipment and knows how to use it, he should be able to handle it. From what I've seen, the horizontal position of the pins could vary from one FSB to another, even within the same brand. I believe he'll have to re-drill one of the holes/notches in the barrel so that both pins will line up.
Link Posted: 8/31/2004 9:02:40 PM EST
Top Top