Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 7/31/2005 7:37:07 AM EDT
[Last Edit: 7/31/2005 6:10:59 PM EDT by P-245]
Ended my range time short with a stuck case. It fired but failed to extract. It is Silver Bear (won't shoot that crap again) and the second time it's happend with this lot of .223. First time I tapped it out with an aluminum cleaning rod; this time no such luck. It's stuck tight. Any help out there? Should I spray some WD40 down the bore in the hopes of getting it between the casing and chamber wall and try to tap it out again?
Link Posted: 7/31/2005 1:41:01 PM EDT
I had a Wolf case .223 get stuck towards the end of my shooting session, my AR would not extract it.
I had to tap it out with a rod? If this happened in battle, you would be screwed, break out the Beretta.
This is the first time this has happen. What causes this? The case has a mark on the rim where the extractor tried to grab it.
Please explain?


Thanks, Perry
Link Posted: 7/31/2005 3:42:15 PM EDT
Take a cleaning rod and tap it out like the previous post mentions.

Link Posted: 7/31/2005 6:15:54 PM EDT
[Last Edit: 8/1/2005 5:40:59 PM EDT by P-245]
Finally got it out. Let it set w/some WD40 in the bore. Went back and tapped some more after several hours - destroyed two sections of an aluminum cleaning rod in the process. Second time it has happened. Yes, the extractor pulled off a piece of the case rim. This has only happened with the Silver Bear ammo - not the Wolf or the AE ammo. Silver Bear is the zinc-plated steel case - not the polymer coated case like Wolf, so there is nothing there to "melt" off and gunk up the chamber. I will run the chamber brush through it often now.
Link Posted: 7/31/2005 6:18:24 PM EDT

Originally Posted By John11167:
Take a cleaning rod and tap it out like the previous post mentions.




Maybe I let it get too dirty. I took it out and out 300 rnds through it, then the next weekend I did the three gun match. I took it out today and put another 300 through it thats when it jammed.
When I took it apart to clean it, the bolt and cam pin seemed dry or sticky.
Link Posted: 7/31/2005 11:01:47 PM EDT
Link Posted: 8/1/2005 3:12:59 AM EDT
Yeh, I got it home and used the chamber brush, its the only way to get in their and get the gunk.
Link Posted: 8/1/2005 3:24:46 AM EDT
Link Posted: 8/1/2005 7:35:23 AM EDT

Originally Posted By Tweak:
use it more often when shooting steel case ammunition



Will do.
Top Top