Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 5/22/2005 3:37:20 PM EDT
Well I ended up with a detent that has a spring that is too short for the bolt release. It went in and now the detent and spring will not come back out.

Any suggestions?
Link Posted: 5/22/2005 3:59:32 PM EDT

Magnet

Link Posted: 5/22/2005 4:00:26 PM EDT
[Last Edit: 5/22/2005 4:02:04 PM EDT by hispeedal2]
What type of magnet?
The ones I have don't seem to be large enough.
Link Posted: 5/22/2005 5:19:35 PM EDT
May have to carefully drill it out and get a new detent. Hold on to the new one with needle nose pliers to make sure it will slip in.
Link Posted: 5/23/2005 7:23:00 PM EDT
Link Posted: 5/23/2005 7:32:40 PM EDT
I had a "specialist" get it out for me- it was a burr inside the hole holding it in.

I have been spoiled by not ever having any issues with the finish of the receiver in fitting parts.

Lesson learned- always check the holes and finger a drill bit to be sure.
Top Top