Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 4/4/2006 12:27:52 PM EST
I noticed that my Stag/CMT M4 flat top upper had a sticking forward assist (the initial push required a lot of force). I removed it at first to clean it but did not find any weird residue. Upon closer examination I discovered the source of the problem.

A section of the pawl kept rubbing against the Forward Assist rollpin. I have no idea why this happened on this setup and not my RRA upper. I used a file and removed some extra material where it was clearly rubbing. I slapped it back together and the FA is as smooth as the FA on the RRA.

The green arrow shows the part of the pawl that needs filing (this is a top view):
Link Posted: 4/4/2006 12:30:10 PM EST
problem solved?

i would have torn it apart as well and put the file to it.
Link Posted: 4/4/2006 12:55:06 PM EST
Yep! The FA works properly now. I could "jam" the FA previously by tugging on it as hard as I could, which would then require excessive force to push in the FA (it would feel "sticky"). Now the FA works like it should! This may not be the solution to all sticky/jamming Forward Assist assemblies, but it would be a good place to start.
Top Top