Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 3/21/2006 7:14:09 PM EDT
Has anyone tried polishing their sear surface with one of those ultra fine rubber cratex bits that Brownells sells? Do you think this would remove too much material and get under the surface hardener?

I just did it myself and along with a reduced power spring, my standard trigger feels much better. Also, I cut the tail off of the hammer with a dremel cutting wheel. If the setup goes to shit, it won't be a problem for me to get a new hammer/trigger.

Anyone else tried this?

erik
Link Posted: 3/21/2006 7:43:36 PM EDT
Tail????


I use CLP and unburnt powder to polish my trigger and sear......
Link Posted: 3/21/2006 7:50:11 PM EDT
[Last Edit: 3/21/2006 7:51:11 PM EDT by avatarhammer]
I've polished the engagement surfaces but never cut anything off. Polishing works great. If you lighten the hammer too much you'll get misfires. Found that out by puttin' in the hammer spring backwards once -- was a nice trigger though.
Link Posted: 3/21/2006 7:55:01 PM EDT

Originally Posted By avatarhammer:
I've polished the engagement surfaces but never cut anything off. Polishing works great. If you lighten the hammer too much you'll get misfires. Found that out by puttin' in the hammer spring backwards once -- was a nice trigger though.



I cut the hammer to look similar to the JP speed hammer.
Top Top