Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/12/2002 11:36:30 AM EST
Who does sear block removals on Colts? My local gunsmith is a moron.
Link Posted: 11/12/2002 3:29:43 PM EST
Link Posted: 11/12/2002 8:31:39 PM EST
Kurt at Kurt's Kustom Firarms does searblock removals. Check him out in the Industry Forum.

Originally Posted By Mongo_Mad:
You will have difficulty getting anyone to do this for you.
Although there is no requirement for the sear block(thanks colt), and it is not illegal to remove it(I think!?!?!?), it's obvious this is the first step in making an illegal conversion. They don't want a visit from the alphabet guys in the near future, asking what they knew and when they knew it. It could be argued you two "conspired" to make a machine gun. That starts RICO, and other silly things. Without even going full auto, they could invent many charges worth hundreds of years each. Hello, Club-Fed.
I suggest you go to where you bought your DIAS and ask them to do it or to recommend someone. And ask them to give a reference for you. You did buy a DIAS or similar, right? You do have some legitimate reason to do this, right?
(Should Have Bought A Bushmaster)

There is nothing illegal here. I removed two sear blocks to facilitate refinishing two Colt lowers. You cannot reanodize a lower with a sear block. Colt will not do a refinish job if the lower has a searblock. Also, you also cannot use a 9mm upper without at least cutting off the top of the searblock or removing it altogether. I could probably think of a few more reasons but I am tired.
Link Posted: 11/13/2002 12:52:24 AM EST
I'm kicking myself daily over the Bushmaster shoulda, coulda, woulda's. But, I have no intention of making a full-auto weapon. I do have two good reasons for needing to get it out:

1. SAWLESALES can't refinish a Colt lower receiver if it has one.
2. I want to put in a trigger upgrade (two-stage, adjustable). Can't do this because there's no room.

Thanks for the tip. I was going to have KKF do some barrel work anyway. I wasn't sure if he did this also. As for the fear factor...when did we wake up in 1939 Germany? You keep your records in order and operate inside of THE LAW, and they can't do a thing to you. My local gunsmith (we only have one-what a shame) also refused to make a pre-ban upper into a post-ban for a buddy of mine. He can't give you a valid reason for why or show you where it says he can't. Just says he can't. How lame is that. He'll never see a dime of my money (he's also a dealer). Probably would have botched the job anyway.

Link Posted: 11/15/2002 12:36:44 PM EST
Frank White of Compass Lake Engineering will take it off. While you're at it, have him put his 2 stage trigger in. It's the best, IMO.


Top Top