Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 4/1/2006 1:50:08 PM EDT
[Last Edit: 4/1/2006 6:09:25 PM EDT by ALAN308]
I have a new YHM flat top riser, a thin one. Cross slot to the rear, 'clamp' to the front. The front clamp has two set screws which spread the slot interface. The typical clamp at the rear is, [horrizontal] typical.
I should like to know tightening sequence and how far 'to go' with the two vertical set screws.
I promised myself, no set screws.


ETA; YHM web site had instructions. Nuthin' to it.
Top Top