Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 12/20/2005 10:00:40 PM EDT
I got a few questions on removing and replacing FH's
1. what tool do u need, Ive seen some armors multitools and such
2.i just got done lookin at some dissambely views on bushys site, what does the chrush washer do?
3. I herd somewhere someone talking about timing, is that like torque or something

im a newb that needs help for an upcoming new AR, actually my first, hopefully be gettin it in feb.
Link Posted: 12/21/2005 2:02:35 AM EDT
Check to see if permanantly attached,Pinned or solderd.

Any tight fitting wrench,the multi tool is a wrench that sometimes does not fit as good as a proper wrench.

The crush washer allows for adjustment of proper timing.

Proper timing is proper relationship of slots,most leave bottom solid and slot top and sides.

If your too far off pre crush your crush washer slightly in a vise between two flat washers so you dont have to crank on your barrel.
Link Posted: 12/21/2005 3:46:12 AM EDT
Get yourself a copy of the TM
Link Posted: 12/21/2005 4:07:08 AM EDT

Originally Posted By Hotgun:
Get yourself a copy of the TM



TM? training manual?
Top Top