Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 9/29/2004 4:25:07 AM EST
I have a Colt M4 "post-ban" upper with muzzle break. How hard should this be to remove and install a f.h? There are two pins going thru the break, top and bottom. You can see thru the pins to the other side, going thru the barrel. I am not sure if the muzzle is threaded or not. Anyone have any experience with this? Thanks Guys!
Link Posted: 9/29/2004 5:58:48 AM EST
Knock out the two rollpins and the comp with slide right off with no effort!
Link Posted: 9/29/2004 6:12:45 AM EST
I've got one too. Anybody know if the barrel is threaded?
Link Posted: 9/29/2004 6:50:14 AM EST

Originally Posted By anykey:
I've got one too. Anybody know if the barrel is threaded?



No, the barrel is not threaded.
Link Posted: 9/29/2004 7:09:38 AM EST
Link Posted: 9/29/2004 11:42:00 AM EST

Originally Posted By TheRicker:
We've done a bunch of these.

Shop Services

hr


And you guys do a great job I might add.http://www.andever-pa.com/images/fh.jpg
Link Posted: 9/29/2004 12:27:56 PM EST
We'll get it off buddy!
Link Posted: 9/30/2004 12:29:28 PM EST
When you remove the muzzle brake on say, a MT6400C, is the barrel itself 16 inches? I'm just curious if a replacement flash suppressor would have to then be permanently attached.
Link Posted: 9/30/2004 12:36:23 PM EST

Originally Posted By Vinh:
When you remove the muzzle brake on say, a MT6400C, is the barrel itself 16 inches? I'm just curious if a replacement flash suppressor would have to then be permanently attached.


Of course it is, otherwise the brake would have been permanently attached.
Link Posted: 9/30/2004 2:40:53 PM EST
It would be nice if some mfg's would make some fh's that would pin on a post ban barrel so they wouldnt have to be threaded.
Top Top