Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 8/4/2005 8:12:42 PM EDT
just got a reprofiled/cut down barrel back from a friend who did the work on it. it is freshly reparked and looks awesome. only problem is, i can't get the FSB to line back up. i understand that the finish has added some thickness to the surface, but if i line up one of the holes and get the pin started, the other has a very definite "ledge" that i can't get the pin started over.
is this just a matter of "beat the living hell out of the pins and they will fit just fine?"
or should i take a different route?
i can take it to my gunsmith-buddy on Monday but i'm kind of antsy to get it built up for the weekend.
any help appreciated.
Link Posted: 8/4/2005 8:34:45 PM EDT
I must be missing this without the visual....

Can you start with the other pin in first?
Link Posted: 8/4/2005 8:48:20 PM EDT
tried that too....whichever hole you "start" with, the other doesn't line up properly.
and just to clarify, it is the same FSB off the same barrel and the same 2 taper pins.....
Link Posted: 8/4/2005 9:05:47 PM EDT
I would start them both, and tap a little on each one. I'm not sure what to tell you without seeing it firsthand. Something sounds a little odd.
Link Posted: 8/4/2005 11:47:17 PM EDT

Originally Posted By Stickman:
Something sounds a little odd.



Yep.
Link Posted: 8/5/2005 6:49:09 AM EDT
Top Top