Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 8/7/2005 6:48:12 PM EDT
I have a RRA upper conversion (upper, block, hammer, bolt, buffer) on my Eagle Arms (ArmaLite) lower. I think I am having problems with my mags. The last round usually always jams (failure to feed). The mags are from Adco and were converted by RRA. Is there a fix or tweak I can do to correct this? Are the mags to blame or the block?
Link Posted: 8/7/2005 8:30:53 PM EDT
You most likely need to flatten out the feed angle of the magazine follower. This is a very common problem with converted Uzi mags. just disassemble the mag, carefully bend the follower legs so the follower is a bit more horizontal, reassemble and try with some snap caps.

Link Posted: 8/8/2005 2:47:40 AM EDT
I put a little drop of JB Weld on the rear of the followers.If I'm not mistaken,Colt mags have a little dimple on the followers.
Link Posted: 8/8/2005 3:04:56 PM EDT
Thanks guys. I will try to bend the follower and see what happens.

Top Top