Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/24/2017 4:44:23 PM
11/22/2017 10:05:29 PM
Posted: 10/28/2004 1:18:19 PM EST
Does the M16 M5 RAS by Knight's require more work to install then just snapping off the old handguards and replacing them with a new handguard. I don't want to have to screw around with replacing the front gas block.

Thanks in advance.
Link Posted: 10/28/2004 1:20:12 PM EST
It is slightly harder than the standard handguards, but the FSB does not have to come off.
Link Posted: 10/28/2004 1:29:10 PM EST
No, the general principle is the same.

Except there is a clamp that slides under the barrel nut that you will have to tighten with an allen wrench. Its possible to do by yourself, but recommended that you have an extra hand. But its a 5-10 minute job max.

Scott
Link Posted: 10/28/2004 1:49:07 PM EST
As long as you remember to loosen that pesky clamp fork allen screw, it's a ten minute job. If you don't, much swearing will follow, until you RTFM .
Link Posted: 10/28/2004 10:39:13 PM EST
Thanks guys for the reply! Now, if I can find someone who has them in stock I'll go ahead and get one.
Top Top