Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 10/20/2002 9:59:22 AM EST
I just acquired an A3 handle, and I noticed when I set it to mechanical zero, the top rear part of the handle (the seperate part that contains the actual sight and knobs)is twisted to the left a bit, not more than a couple millimeters or so. I can straighten it, but it is apparently spring loaded, and always returns to the left. Is this common, and is it going to affect on my already dismal aim?

Link Posted: 10/20/2002 10:08:49 AM EST
Yes it's common and no it won't affect your {I'm sure More than adequate} aim
Link Posted: 10/20/2002 8:59:22 PM EST
Appreciate it!
Link Posted: 10/20/2002 9:41:02 PM EST
[Last Edit: 10/20/2002 9:41:29 PM EST by Big-Jerk]
Mine was twisted one way too but I fixed it.

I put an ACOG on it.

Link Posted: 10/21/2002 2:05:51 AM EST
Are the A3 handle sight as accurate as the A2 sites? ...is there a need to re-zero when you remove and replace them?

Link Posted: 10/21/2002 6:21:52 AM EST
Oh yeah, one more question. Is an A3 upper with the A2 carry handle / sight CMP legal?
Link Posted: 10/21/2002 2:34:54 PM EST
For your last two questions -
The removable handles (A3) have A2 sights on them, so yes they are exactly as accurate. Mine returns to zero every time after removing the handle.

For CMP use, some smaller matches might let you use a handle equipped A3, but any larger match will require a permanent handle ala A2. At the BRC highpower match last June, they were allowing A3's, as does the dinky little local monthly match where I live. Anything with more than a few shooters will likely require A2.
Top Top