Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 9/7/2003 6:56:53 AM EST
What would cause the firing pin to dimple a live round slightly when cycling the action?
I can cycle the action then pull the bolt to the rear ejecting the round to find a dimple in the primer. It shoots fine no other troubles.
the rifle is a Bushmaster Varminter, and factory Winchester ammo.
Thanks for your time
O-S
Link Posted: 9/7/2003 9:10:47 AM EST
This is completely normal for a AR!! Since the firing pin is floating with no spring, the intertia of the firing pin will cause the it to hit the primer when a round is chambered. This is why in fact CCI make a primer with a thicker cup for AR type rifles!! For you info, when I reload I have used standard rifle primers without any problems Stuart
Link Posted: 9/7/2003 12:32:53 PM EST
Thank's Stuart I suspected that it was normal , by the way it is built, but i wanted to be sure. I guess i never took time too look at the primers on unfired rounds before in a AR. Thanks again O-S
Link Posted: 9/7/2003 4:48:23 PM EST
No problem, I'm glad I could help Have Fun, Stuart
Top Top