Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 10/22/2002 4:23:27 PM EST
I seen some of these on Gunbroker and was wondering if they are quality or not...
Link Posted: 10/22/2002 5:25:06 PM EST
Link Posted: 10/22/2002 9:07:17 PM EST
Link Posted: 10/25/2002 11:21:44 AM EST
Cheaper than Dirt had some, and they were quite filthy, and well worn. It was necessary to disassemble and SCRUB with a bottle brush and hot soapy water. After this, they seemed smooth, though a few had cracked feelips.

Like Troy, I would use these ONLY for range use.

But before buying these, I would advise spending your money on USGI mags, any manufacturer except Cooper.

Even Coopers may be alright IF:

(1) the welds look OK. Chisel down the price, and use them for the mag body and floorplate only. Put in a new spring and green follower, and it will function OK.

(2) All Coopers I have seen had weak springs, and would not feed the last 5 or 6 rounds. The spring was so weak the follower could not actuate the bolt stop.
Link Posted: 10/26/2002 1:42:58 PM EST
Try to buy on sight or roll dice on bulk. Some have cracked feed lips from age/heat. Good beater range mags overall for $10, much better off with used USGI for $15-20 IMO. And I like my $20 new Thermolds, so I am not anti plastic mag. Orlites are just often tired.
Top Top