Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/5/2006 4:49:04 PM EST
Would Norrells molycoat be ok to use on a stainless barrel or would it be better to use the Duracoat hi temp coating? Anyone have any first hand experience with this? I used Duracoat hi temp on my operator and it has been great. Just wondering if the Norrells or standard Duracoat would hold up to the heat. Thanks for your help, Tom
Link Posted: 3/7/2006 10:46:28 AM EST
Link Posted: 3/7/2006 10:51:59 AM EST
from what I recall from previous posts, Duracoat hi temp is what you should use on the barrel.
Link Posted: 3/7/2006 11:01:20 AM EST
Link Posted: 3/7/2006 1:24:44 PM EST
Norrell would be better than the Duraheat or Cerakote.

The high-temp coatings are not abrasion resistant and will scratch off much easier.

The Norrell is high temp enough to do a stainless match barrel and more dureable.

Even on silencers I prefer Norrell (or Gunkote) to the high-temp coatings. I only burned it off once and I had to use a belt-fed.
Link Posted: 3/7/2006 1:38:47 PM EST
Make sure you sand blast the barrel first or no finish will stick.
The sand I use is Quickcreat medium grit leveling sand it can be had for less than $10.00 for a
100 lb. bag.
Link Posted: 3/7/2006 1:40:43 PM EST
The instructions for Norrell say to use Aluminum oxide and you must not use glass beads.

Are you sure sand is sharper than glass beads?
Link Posted: 3/7/2006 1:44:44 PM EST
[Last Edit: 3/7/2006 1:46:28 PM EST by Stickman]
Link Posted: 3/7/2006 2:13:15 PM EST
You guys are great. Thanks for the input. I've read the fantastic refinishing thread and had great results with Norrells. I just wasn't sure that it was right for a barrel. Thanks again. Tom
Top Top