Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Site Notices
Posted: 4/17/2008 2:51:52 PM EDT
Been on this site for a long time learning all kinds of great stuff, its been a great resource. I have a Bushmaster V Match and wanted to change the tube for a Daniel Defense rail. There is not a front sight post.  So is major dissasembly inevitable or is it easy? Again I am new at this and really appreciate your time.
Link Posted: 4/17/2008 3:01:01 PM EDT
Pay to have it done.
Link Posted: 4/17/2008 3:01:04 PM EDT
very easy knock out the two pins that hold the front sight on and pull it off and unscrew the hand guard, put the new one on in reverse order just line up the gasstube hole on the hand guard
Link Posted: 4/17/2008 3:03:13 PM EDT
I may be retarded but what side do the pins come out?  They look to be same size on both sides. Thanks again..
Link Posted: 4/17/2008 3:14:31 PM EDT
If you have a dpms FF tube currently on your rifle you may have difficulty getting it off. They use loc-tite so if you use a torch and heat the threads a bit you can break them loose with a strap wrench.
Link Posted: 4/17/2008 7:30:16 PM EDT
[Last Edit: 4/17/2008 7:32:08 PM EDT by mince]
height=8
Originally Posted By eastTXhunter:
I may be retarded but what side do the pins come out?  They look to be same size on both sides. Thanks again..


The FSB tapper pins remove from left to right.  Install right to left.

If there are no pins, it's lock-tited on.
Top Top