This is my first midlength upper and stainless steel barrel. I've been holding off until dennysguns advertised this barrel with the gas block which released all my pent up frustrations.
Barrel markings:
Troy irons deployed:
With Aimpoint M2:
With TA31F ACOG:
With Nightforce NF NXS 2.5-10:
Different view:
Specs:
Noveske 16" stainless midlength barrel, 1x7 twist, 5.56 chamber, M4 cuts, stainless gas block already installed with taper pin and set screw.
Smith Ent. G6A2 vortex flash hider
Larue 12.0 free float rail
CMT M4 cut flattop upper
Charging handle with PRI big latch
RRA enhanced bolt carrier assembly
Troy front and rear BUIS
Preban PWA lower
Magpul MIAD
Chip McCormick 2 stage trigger pack
LMT SOPMOD stock
Ordered on a Friday, showed up on Wednesday morning. Assembled soon afterwards. The barrel is quite impressive. This is also the first time I've owned and installed a Larue rail. Presently all my rails are KAC. I'm sold on the Larue now too. Now that I've officially caught the midlength bug, I'm going to order one of those Operator barrels for yet another upper project. Will it never end???
Thanks to dennyguns and ADCO for the stuff I needed to build this project.