Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 7/2/2003 3:27:08 PM EST
Have a Gemtech Talon SD 9mm upper for my M-16. Due to the design of the suppressor, there is no front sight on this gun, and it is currently sporting a HoloSite red dot on the flattop which works nicely. However, I was wondering if there is an ARMS or other unit that might bolt onto this gun that would allow the installation of a front and rear sight assembly so I can shoot it with iron sights.....

Any assistance would be appreciated....

Link Posted: 7/2/2003 5:04:31 PM EST
Link Posted: 7/2/2003 8:23:44 PM EST
You could mount the KAC front sight Troy mentioned directly to the flat top. This will work, but not very well. Do you have a pic of the upper (or a link) that I could see to get an idea of what you are trying to do.
Link Posted: 7/2/2003 9:29:08 PM EST
Link Posted: 7/2/2003 11:30:54 PM EST
I have one of the KAC 9mm SD uppers.It is very similar to yours but it does use a FF RAS.I came with KAC's front and rear sights.If your can will fit inside a FF RAS you can use KAC's sights.I know that you can put a M4 RAS on your upper.If it mounts secure enough you might try KAC's front sight on it.SJR556.
Link Posted: 7/3/2003 9:46:59 AM EST
Thanks guys - I know this is a stupid question, but what is a FF RAS?
Link Posted: 7/3/2003 9:51:17 AM EST
I believe the M4 RIS version will fit on your Talon. Another board member (drfcolt?) has done this.
Link Posted: 7/3/2003 10:08:20 AM EST
Link Posted: 7/3/2003 10:19:32 AM EST
cool. thanks guys. i guess what i'm hearing is that yes, it can be done. looks like it would cost a fair amount of $ just to get a front sight on that puppy.....but hey, its only money right???
Link Posted: 7/3/2003 1:05:37 PM EST
I believe you will have to remove the heat shield for the RAS to fit over the supressor. There was a 2002 article in "special weapons" magazine in which the author did just that.
Top Top