Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/9/2006 10:54:02 AM EST
[Last Edit: 2/9/2006 11:22:57 AM EST by georgejetson]
I want to cut a barrel to 16" but dont know how to restore the crown area, I have acces to a full machine shop, any body has a print or any info on dimentions and how to?
Link Posted: 2/9/2006 5:39:14 PM EST
I normally face the barrel to an 11 deg. target crown, i then put a 45 deg. crown on the rifling using a specially ground carbide cutter. When i crown the rifling i pull the cutter out from the bore so as not to push a burr into the barrel. Dont just put the barrel in the chuck and start cutting. Take the time to indicate the barrel so there is NO runout. For best results use a 4- jaw chuck. A barrels I.D. and O.D. are not always concentric so take your time and do it right, good luck PATRIOT ARMORY 07 FFL
Link Posted: 2/10/2006 3:50:46 AM EST
Big +1 patriotarmory223. Charles the Gunsmith.
Link Posted: 2/10/2006 8:40:12 AM EST
Link Posted: 2/10/2006 9:52:32 AM EST
[Last Edit: 2/10/2006 9:56:37 AM EST by georgejetson]
Patriotarmory223 THANKS A MILLION your the man that is what I was looking for and AR15barrels great picture now is time to go and do it THANKS>.........
Top Top