Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/14/2003 6:01:37 AM EST
I'm working of integrating an ARMS #38S-Ex -MOD with an Aimpoint CompM2 and a KAC flip up front. see->



1 - it looks like the Aimpoint is lower than others I've seen here. Looking through the flip up rear, the red dot seems dead center to me. Is there any way to know for sure? Do I need a new mount for the Aimpoint? (BTW, I can't fire it to find out. The suppresser has not yet arrived )

2 - The KAC front is too tall. I don't know of any front sight that will work with this, so I just want to shorten the part that flips up by taking some off the bottom. Question is, how much lower should it be?

Shouldn't someone have a chart of line of sight information to determine what works with what?????

Thanks for any assistance!!!!!!!

Link Posted: 11/14/2003 6:17:08 AM EST
[Last Edit: 11/14/2003 6:23:30 AM EST by mr_wilson]
Your using the X-ring ML2 mount, which would co-witness perfectly on a RRA Tactical upper, but not on the ARMS. You need an ARMS #22M68, mount w/ NO SPACER to co-witness with what you have, BTW, this set-up and your question in general has been discussed on many many many threads..... here. Mike added: the PRI was not designed to be mounted on the ARMS rail, it should be on the gas block rail, which I assume is under the handguard, as to how much to whack off I have NO clue. Your one of those guys who enjoy going the long way around the barn, aren't cha? [;)] Nice looking "boat anchor" ya got there....[:)]
Link Posted: 11/14/2003 12:10:19 PM EST
Link Posted: 11/14/2003 1:10:53 PM EST
.460" ... thanks Troy. I think that's what I needed. When I started this (about a year ago) I wanted to use the PRI FF tube and lock the ARMS#38-MOD to it as it does to the KAC FF RAS. Everyone said, "Can’t do it." I said, 'well, maybe YOU can't do it. But me, a drill, and tap can." While working out details with the barrel/suppresser, PRI started making top rails with the hole for the #38-MOD. Seems I wasn't the only one who wanted it. So, Dave (I think) at PRI hooked me up. My plan is to completely ruin a good KAC flip up front sigh... um I mean, lower the front sight by taking out the pin that the tower pivots on, Drill it .460" higher, remove .460" off the bottom, and reassemble. Or something like that. Depends on how far around that 'ol barn is. [:o)] --LS
Link Posted: 11/14/2003 1:54:20 PM EST
HMMMM, Yep, ya can take the o'l hack saw to the range as the front sight adjustment tool:) Good shootin, Jack
Top Top