Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Site Notices
Posted: 10/6/2005 4:03:22 PM EDT
[Last Edit: 10/6/2005 4:03:59 PM EDT by Hylton]
I have a  Bushmaster M4/A3 Government AR-15 with a 16" profiled barrel with a standard bird cage flash suppressor. Now to my question, I wanted to change my  flash suppressor with this DPMS , how do I do so. Will it screw on and off? Will a DPMS part work on my Bushy? thanks
Link Posted: 10/6/2005 4:10:07 PM EDT
Yah, unscrew the A2 and screw on the new one.  No sweat.
Link Posted: 10/6/2005 4:15:18 PM EDT
Is that a phantom clone - i.e. it works as good as an orginal phantom?  Don't know if whoever owns the phantom designg (YHM?) has it patented or not?  

If not, an original phantom is only like $5.00 more.  


(Of course if you already own it, it's a moot point).
Link Posted: 10/6/2005 4:22:27 PM EDT
Yep, it is threaded normally (i.e. not left handed threads) so just unscrew the A2 and thread this one on.

DK-Prof, it might be from YHM. The last 2 letters in the part number are "YM".

Course, I'm just grasping at straws here

WIZZO
Link Posted: 10/9/2005 2:16:09 PM EDT
I tried to remove the A-2 today by hand and it wouldn't budge, how do I remove this?
Link Posted: 10/9/2005 2:19:28 PM EDT
Link Posted: 10/9/2005 2:24:30 PM EDT
Thanks, will do, how do I prevent the wrench from damaging my flash hiders?
Link Posted: 10/9/2005 6:16:22 PM EDT
Link Posted: 10/10/2005 7:27:07 AM EDT
[Last Edit: 10/10/2005 7:27:25 AM EDT by eye_spy]

Originally Posted By JTAC_Supply:
Tape :)  Electrical tape on the flats will work fine.

J



+1


only I use Duct Tape.
Link Posted: 10/10/2005 8:02:02 AM EDT
I have read where some have needed to apply heat to their FH's to free them

Of course, limited heat to prevent marring the surface finish.

Maybe a propane flame to loosen the loctite's grip - but only localized and briefly

Link Posted: 10/11/2005 1:04:36 AM EDT
[Last Edit: 10/11/2005 1:05:54 AM EDT by Hylton]
When I’m installing my Panther flash hider what steps should I take to make sure it is properly installed?  Do I still need to install the lock washer? I was also wondering if the Panther flash hider had any more length over the birdcage A2 thats on my gun now?
Top Top