Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Site Notices
Posted: 6/20/2017 7:09:19 PM EDT
Hello Everyone - I'm sure this question has been asked a bunch of times. I am building my first AR15 and need to make the barrel NJ compliant. From what I have learned, the opening diameter at the end of the compensator needs to match that of the barrel. So, I am looking for a compliant compensator. I see one in the AR15 store (link below) that looks like it will do the trick. Is this NJ compliant?

https://store.ar15.com/product.html?cat=108&pr=650

Seems it would be given it is pre-drilled. Just want to make sure. Other than this one, what are other NJ folks using?
Link Posted: 6/20/2017 11:53:25 PM EDT
You'll have MUCH better luck with this in the NJ subsection.
Link Posted: 6/21/2017 7:41:41 AM EDT
^^what he said.

My state used to have a similar law. Muzzle brakes/compensators only, no flash hiders. Retarded yet it is the law.

The item you linked to looks like it will do the trick. I believe in NJ you also have to pin and weld it. If it is going on a 14.5" barrel then you need to pin and weld it anyway.
Link Posted: 6/21/2017 7:53:46 AM EDT
Thanks so much. Didn't realize there was a NJ section.
Link Posted: 6/21/2017 10:46:57 AM EDT
[Last Edit: 6/21/2017 10:46:57 AM EDT by Eric802]
OP has re-posted in the NJ forum
Top Top