Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 3/18/2006 4:03:21 AM EDT
Hello,

I am not sure how to remedy my problem:

I have a KAC RAS II and it seems to be pinching my gas tube. it pushes on the gas tube in such a way that it stops the bolt from glosing easily. I have to use the FA to close it an additional 1/8" of an inch. This is enough to cause a mis fire.

Any suggestions or remedies?

Thank you in advance.
Link Posted: 3/18/2006 12:38:21 PM EDT
Link Posted: 3/18/2006 9:12:46 PM EDT
Thank you very much for your post!

I never thought about taking the bolt out and cycling it to pin point the problem.

I did what you said and cycled it without the bolt, it seemed fine. This made me worried.

I than reassembled the bolt and carrier and found that the gun works fine now... Go figure... I did not locate thr problem, it may have loosened up as I relubed all the parts and let it sit.

This gun doesnt get shot as much as it deserves.

I will hope to test it on the range soon.

*** This is a fairly new armalite but I recently changed the 20 thin barrel to a 11.5" heavy barrel with a tactical setup.

Here is a picture for you interst:
http://img.photobucket.com/albums/v680/t6chan/AR15/IMG_1049_2.jpg

Regards,

Tony
Top Top