Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 10/17/2004 3:08:56 PM EST
I had been looking at BUIS for a few weeks and lucked up on a deal for 2 Matech flip-up rear sights, the ones with the yardage marked off on the left adj. and windage knob on the right. I hadn't seen anything on these here but both of them, NIW with instructions for $100.00, seemed like too good a deal to pass up. Did I do good or is there some problem with these sights, other than the aperture maybe being a little fragile when in the upright position?

Danny
Link Posted: 10/17/2004 7:09:30 PM EST
Link?
Link Posted: 10/17/2004 7:13:18 PM EST
I havent ever heard of any problems with them. Assuming its the design you wanted, it ought to work well.
Link Posted: 10/17/2004 7:44:07 PM EST
No link. These were from an individual.
Link Posted: 10/17/2004 9:16:31 PM EST
I like them, they're just hard to find...

IM sent
Link Posted: 10/18/2004 12:52:57 AM EST
IM doesn't seem to work. ?????????
Link Posted: 10/18/2004 6:11:18 AM EST
Danny,
$100 seems like a good deal, and if all you use is an Aimpoirt or EOTech than it's a decent option.

IMHO the MATECH takes up too much rail real estate, and makes mounting certain scopes impossible (not enough eye releif).
Link Posted: 10/18/2004 10:16:22 AM EST
I like mine.
It fits right under my ACOG TA-01.
Very easy to use, and provides windage, and has pre-set clicks for 200-600yds.
Made of steel, and very rugged.
Don't overtighten the mounting screw. It can break if overtightened. Just tighten it enough and leave it.
It only covers the back 2 slots on the 1913 rail, so I don't think it takes up too much "real estate".

My 2 cents, and I own one.
Top Top