Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 10/5/2004 2:49:41 PM EST
I am converting a 14.5 inch barrel to 16 inch legal.
I am going to use an A2 flash hider, The hole has been drilled for the roll pin.

The part I don't know is where do I measure from at the reciever end to get
16 inches to the end of the flash hider.

Do I start from the edge of the feed ramps or the bginning of the chamber????

So the real question is how thick does the spacer have to be????

Thanks
Link Posted: 10/5/2004 2:56:55 PM EST
Link Posted: 10/5/2004 3:00:39 PM EST
An A2 flashider won't get you over 16"
You need to permanently affix a Vortex or a Phantom or similar length flashider to get over 16"
You measure from the bolt face to the end of the barrel.
Link Posted: 10/5/2004 10:51:34 PM EST
Correct. An A2 f/s will NOT get you to the legal 16". You must use either a Phantom or a Vortex. Both are better anyway than the A2.

If you must have an A2, some companies make an A2 f/s that is longer than the origional. ONLY the longer A2 will get you legal.

TheRicker is right about how to measure bbl length.
Link Posted: 10/6/2004 3:51:37 AM EST

A GemTech Bi-Lock will also get you out to 16", and makes it easy to use a nice QD sound suppressor down the road. Once you've got a Bi-Lock on there, it will remind you every day to get into the NFA game and buy the matching suppressor soon (at least, that was my theory ).
Top Top