Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/22/2020 12:12:56 PM
Posted: 2/15/2006 9:24:24 AM EST
Monday about noon I ordered a 16" mid-length complete kit, primarily for the upper and to have some parts for the NEXT build. I called today for a tracking number around noon and was told by them it was out for delivery. I was SHOCKED. Usually it seems to take most people a couple of days just to get something out the door. The big brown truck dropped off the kit about 1:00 p.m. today. The upper is on my lower and the parts look great.

Their 16" midlength A4 is built on a Rock River upper. Everything looks great and the fit is T-I-G-H-T! No movement at all between the upper and lower. The upper and barrel extension have m4 ramps that are done right. at least looking at them.

I cannot wait to shoot it- i'll report the results.

I went back & forth about who to order from. There are a lot of great vendors, especially on this sight. I looked at J & T, Del-Ton and Model 1 but couldn't find the midlength I wanted from any of them.

If this thing shoots anywhere near what it looks like I will be ecstatic. M & A's service (delivery) is first rate. So far, I would reccomend them to anyone.

Bill D
Link Posted: 2/15/2006 10:14:10 AM EST
bring on the pics
Link Posted: 2/15/2006 11:53:15 AM EST

especially of the M4 ramps.

RRA usually dremels them in. Are yours anodized or bare aluminum?

Link Posted: 2/15/2006 11:53:46 AM EST
[Last Edit: 2/15/2006 2:11:08 PM EST by RatSass]
Nothing fancy- I'll see if I can manage a pic.

This is my first AR since the AWB so the only one with anything on the end of the barrel. Sure looks good. And it isn't an A4, it's a flattop A2 (I guess). Went with the standard A2 stock but I've got a couple of A1's on order. I don't care so much for "Tactical" as all I'll do with it is tactically punch paper and occasionally tactically punch a hole in a coyote at the farm. I did install an A.R.M.S. #38 Swan Sleeve with the integral flip-up sight and right this minute it's wearing the El-Cheapo red dot I bought for another AR just to play with. Maybe someday- an Eotech, Holosight or other good sight- we'll just have to wait and see. If it shoots less than an inch like my RRA 20" A2 I may just go with a scope. The 20 is free floated so I am not holding my breath. Feed ramps are milled into the upper apparently AFTER anodizing and/or finishing- like an afterthought. Can't get a good pic but they are well done. Better than "dremel" work.

Link Posted: 2/15/2006 3:53:26 PM EST

After looking more closely, I don't think they are M4 ramps, but someone felt the need to relieve the upper below them.

Bill D
Top Top