Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 2/23/2016 2:34:02 PM EST
Anyone know how this was accomplished?

Link Posted: 2/23/2016 2:55:47 PM EST
Install the hand guard cap behind a low-pro or cut down gas block, IIRC. There's been a couple threads on it from long ago.
Link Posted: 2/23/2016 3:04:09 PM EST
It would appear in this picture that the handguard cap is against the rear of the comp. It does not look like there is room for a gas block or that it would be positioned over the gas port.
Link Posted: 2/23/2016 3:07:35 PM EST
Yep, just a hand guard cap behind the low pro gas block. For a clear example, look up the Core 15 100429 AR15. It has the regular M4 hand guard installed from factory, using a lo pro gas block and end cap. Just swapped the hand guard out for a friend and installed a moe guard in it's place.
Link Posted: 2/23/2016 4:14:16 PM EST
[Last Edit: 2/23/2016 4:14:58 PM EST by graysonp]
Link Posted: 2/23/2016 7:57:27 PM EST
That must be it, thanks.
Link Posted: 2/23/2016 8:17:53 PM EST
I did something very similar with a 300blk barrel for hunting.

I used a shaft clamp off Amazon and stainless steel spacer. Turned out great and locks up pretty solid. Several days back and forth to my ladder stand and didn't work loose.

Final product



What it looks like under, a little ugly but you can't really tell once complete




So very pretty!!!

Link Posted: 2/23/2016 8:23:21 PM EST
hera arms gen 1 linear comp if that helps
Top Top