Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 9/29/2011 11:58:05 AM EST
Which retainer do you need to run MOE handguards??? Round or triangle?? The piece right behind the FSB
Link Posted: 9/29/2011 12:03:31 PM EST
[Last Edit: 9/29/2011 12:04:01 PM EST by wrighteouskill]
They will fit either. However, all carbines(gas system) use round handguard caps. Midlength, and rifle (gas systems) use the triangle. UNLESS its a DOI
Link Posted: 9/29/2011 12:23:26 PM EST
Originally Posted By wrighteouskill:
Midlength, and rifle (gas systems) use the triangle. UNLESS its a DOI


not always

Link Posted: 9/29/2011 12:30:02 PM EST
I just installed a MOE on my middy. (triangle)
Link Posted: 9/29/2011 12:38:03 PM EST
Either will work. If it doesn't, you have them upside down.
Link Posted: 9/29/2011 4:10:36 PM EST
Good to know.. I have a delta ring assembly and the cap on the end I pulled from another build to install a samson evolution. Glad I did not cut the delta like some do.. Thanks for the replys
Link Posted: 9/30/2011 9:26:48 AM EST
[Last Edit: 10/3/2011 10:42:27 AM EST by wrighteouskill]
Originally Posted By DanNH:
Originally Posted By wrighteouskill:
Midlength, and rifle (gas systems) use the triangle. UNLESS its a DOI


not always



When? b/c that is the standard in the AR world. No disrespect, I just am curious know.
EDIT: Only if your doing retro with carbine Triangle HG's
Top Top