Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 12/30/2005 5:56:52 PM EST
So they can just fall straight through. How can I fix it? (I know the KNS kit is one solution).

Link Posted: 12/30/2005 6:07:52 PM EST
[Last Edit: 12/30/2005 6:08:29 PM EST by Tweak]
Link Posted: 12/30/2005 6:14:47 PM EST
[Last Edit: 12/30/2005 6:15:11 PM EST by -C4-]
Yeah I know. I just thought they were supposed to be tighter than this. These are much looser than either of my other two ARs were. Either that I think i'll just stick with the KNS pins I cut down to fit.

Link Posted: 12/31/2005 3:05:04 PM EST
Link Posted: 12/31/2005 3:26:08 PM EST
Unsure... my guess... between .156 and .157... The KNS pin kit will hold them fine, with no rattle, but I wasn't sure if that is a reasonable fix...

Link Posted: 12/31/2005 3:27:03 PM EST
Make sure that the springs are properly placed. If they are placed well then the diameter of the pins should be of no consequence. If the small diameter is just annoying you, perhaps you can obtain some of the oversized RRA pins.

Good luck.
Link Posted: 12/31/2005 3:34:45 PM EST
Link Posted: 12/31/2005 7:15:23 PM EST
Pins are .1555.... though, no... I don't have calipers.

Top Top