Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 10/31/2003 5:41:18 PM EST
Dangit, something else loosened on my Bushmaster. First the carrier key screws and now this. Took it out of the case today and the stock could be turned. No idea why, the darn thing hardly leaves its softcase.

Anyway, I got it tightened up a bit but want to make sure its good and tight. Any recommendations for someone without a spanner wrench???

Also, is this a fairly common occurance or am I just cursed??? Gun's about two years old and has had maybe 2000 rounds through it.
Link Posted: 10/31/2003 5:52:13 PM EST
Don't know how common this problem is, but without sounding cocky the best thing to do is to get a spanner wrench(they're cheap). Without a spanner wrench, try a hammer and a punch.
Link Posted: 10/31/2003 5:53:36 PM EST
You could use a strap wrench. Or you could go to CDNN and buy a CAR wrench. They are on sale for $1.99. [url=http://store.yahoo.com/cdnn/arbutwrennew.html]CDNN AR buttstock wrench[/url]
Link Posted: 10/31/2003 6:01:03 PM EST
instead of buying a strap wrench, you can use an old fan belt availible at any auto parts stores. Or, Take a punch and put it in the detent slot on your lock nut, then take a hammer and drive it tight. As far as the stock comming completely off, just tighten up the nut holding the lever in place and applying some locktite. I also bought a really cheap collapseable and had simaler problems. Good Luck; I hope this helps.
Link Posted: 10/31/2003 7:03:32 PM EST
Put some lock tite on the buffer tube threads and you can use the edge of a flat tip screw driver,be carefull of the threads and tap lightly till the nut gets tight.
Link Posted: 10/31/2003 8:19:39 PM EST
Use a giant set of plyers and wrap the teeth with alot of tape. I just had to do it to both of mine and it worked great. I even had loctite on the threads but it worked like a charm.
Link Posted: 11/1/2003 4:04:53 AM EST
When I installed my stock,using a cheap CAR ranch, the little tooth that fit in the ring grove bent easily. So I used a small punch to finish the job, also used loc tite, it has held up great. [IMG]http://www.metrophotohost.com/gallery_0010/gallery_albums/TGs-LBV-~-MBR-~-Etc/ForendgriponAR.jpg[/IMG] TG
Top Top