Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 6/4/2003 2:47:35 AM EST
Does anybody make slightly longer takedown pins?

My Texas Armaments receiver is built like
a tank and the extra metal means the takedown
pins are just flush with the receiver rather
than slightly protruding like in mil-spec
receivers. It would be nice to have a little
protrusion with slightly longer pins.
Link Posted: 6/4/2003 4:35:16 PM EST
[url]watsonsweapons.com[/url] sells a rear take-down pin that has a small "handle" on the right side. Because the FAB10 ( Kaliban legal lower) has to be opened to be loaded, I modified some front pivot pins, by lengthening the detent slot, to replace the take-down pins. However this leaves about an 1/8" sticking out the left side (which is what I wanted).
Link Posted: 6/4/2003 5:58:39 PM EST
Originally Posted By geardoc: My Texas Armaments receiver is built like a tank
View Quote
Damn, things really are BIGGER in Texas !!! [headbang]
Link Posted: 6/5/2003 2:34:23 AM EST
notack, Thanks; I emailed them about their pins. I'd guess that Kalifornai would be spawning lots of new ideas like this. I'm a little surprised the the big handled pins haven't caught on with the benchresh & CMP folks since they are often opening the receiver for cleaning.
Link Posted: 6/5/2003 2:42:29 AM EST
Mil spec? Just a lower end guide-line for this receiver. ...ref... Damn, things really are BIGGER in Texas !!! [headbang][/quote]
Top Top