Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 8/10/2005 1:17:34 PM EDT
I recently purchased a Yankee Hill 5C2 Phamtom supressor. I'm having a problem lining up the closed slotted section up so it is at the 6 o'clock position. When I screw it on on the barrel it lines up around 1'oclock. Does anyone have any ideas how to correct this?
Thanks,
Link Posted: 8/10/2005 2:02:20 PM EDT
You've got a crush washer right?

You need a crush washer or a peel washer.

If you bought the suppressor new it should have came with a crush washer.
Link Posted: 8/11/2005 4:17:21 AM EDT

Originally Posted By Ridge:
You've got a crush washer right?

You need a crush washer or a peel washer.

If you bought the suppressor new it should have came with a crush washer.



+1

you need a washer. If you're not using one don't try to force it.

Does anyone know if the 5C2 affects accuracy?
Link Posted: 8/11/2005 5:31:58 AM EDT
Link Posted: 8/11/2005 7:22:15 AM EDT
[Last Edit: 8/11/2005 7:22:47 AM EDT by Beyond_Visual_Range]
is that the 5 slot version? Get a crush washer, but I've had problem crushing them in the past, so I usually use sand off the washer little by little until it's 1/4turn from desired position and then try to clamp it down and crush it to size.
Link Posted: 8/11/2005 1:23:42 PM EDT
crush washer helps to align the ports.



what i do to crush it to make it easier is tighten, loosen, tighten a little more, loosen and tighten till i get to where i need to be.
Top Top