Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 12/26/2005 7:30:51 PM EST
I'm about to start on a .458 build and was wondering which forearm would be better. The YHM is only 1oz heavier and more than 1/2 the cost of the DD.

What do y'all think?
Link Posted: 12/27/2005 4:33:15 AM EST
I say go with the DD - but I may be a little bit biased...




Spooky
Link Posted: 12/27/2005 6:11:46 AM EST
after using larue i dont think i can go back to yhm
Link Posted: 12/27/2005 7:26:06 AM EST

Originally Posted By Spooky130:
I say go with the DD - but I may be a little bit biased...


images.snapfish.com/34588%3C989%7Ffp58%3Dot%3E2336%3D4%3B7%3D575%­3DXROQDF%3E2323834689593ot1lsi

Spooky



what gas block did you use?
Link Posted: 12/27/2005 7:33:20 AM EST
DD has the better locking system and proper M1913 rails.

The YHM rails has that groove going down the middle, which is an issue if you use a KAC style VFG, if that is not an issue then there is no reason not to go with the YHM.
Link Posted: 12/27/2005 7:38:34 AM EST

Originally Posted By BadSVT:

Originally Posted By Spooky130:
I say go with the DD - but I may be a little bit biased...


images.snapfish.com/34588%3C989%7Ffp58%3Dot%3E2336%3D4%3B7%3D575%­3DXROQDF%3E2323834689593ot1lsi

Spooky



what gas block did you use?



A Badger low profile... Not a lot of room between the barrel and the tube. I also lost the gas block while shooting - make sure you secure it very well...

Spooky
Link Posted: 12/27/2005 7:40:39 AM EST
i think i'm going to go with the YHM since it provides the most clearance. I'll probably also remove a little bit of material from the block too for just a little bit of extra clearance.
Top Top