Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 6/7/2003 10:40:25 AM EST
I noticed today that I can actually grab the gasblock on my flot-top upper and MOVE IT back and forth about 1/16" (approximately). Is this a bad thing and can it affect the functioning of my rifle? Unfortunately, I'm pretty sure my warranty has expired on it so is it something I can repair myself?
Link Posted: 6/7/2003 11:04:43 AM EST
The gas block shouldn't move. Is it a pinned front sight or one of the rail type blocks? If it's pinned, it would indicate that the pins have enlarged the cuts in the barrel in which case it would need to be drilled for larger diameter pins - if it is a rail type, they are usually held in place with a set screw so try to tighten it. Whatever the type, you will be losing a degree of gas from the block but not enough to cause a malfuction, just keep your hand away from the gas block when firing. Even if the warranty is out, I would imagine the manufacturer would take care of this.
Link Posted: 6/9/2003 4:53:32 AM EST
I have an aluminum gasblock on a flat top... It blew off after the first couple pops. Nice! I drilled the set screw holes to a bigger size, tapped them accordingly, and used longer set screws. They stick out a little, but the gas block does not budge.
Link Posted: 6/9/2003 12:29:21 PM EST
Well, thanks for the replies. I found the problem WAS in fact a loose set screw on the bottom of the gasblock. The funny thing is that there are two places for them but only one is drilled out. Should I put some Loctite Blue on the screw and torque it down or should I drill out and tap the other hole?
Link Posted: 6/10/2003 10:16:21 PM EST
use the other hole also
Link Posted: 6/11/2003 5:17:37 AM EST
Loctite as well. Not a bad thing!
Top Top