Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 6/27/2003 1:56:42 AM EST

see my post here:
my just-arrived-in-the-mail KAC single point mount won't mate with my recent production bushmaster lower receiver. it would appear from a follow-up posting that the hole in the BM lower is "out of spec" by a few thousandths of an inch; in combination with the KAC mount (which is similarly oversize by a few thousandths) assembly is not possible.

jim aka ar-jedi

Link Posted: 6/27/2003 2:31:16 AM EST
I had tthe same exact problem, but used a lil' lube and BFH. That did it. When I pulled it off, only the finish was worn.
Link Posted: 6/29/2003 8:10:38 AM EST
I hused a needle file to take the finnish off the lug. Once down to bare alluminum the fit was perfect.
Top Top