Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 6/10/2003 3:10:31 PM EST
I have a Bushy A2 and I can't figure out how to get the original A2 grip off.....The "screw" or whatever it is in the bottom looks weird and I don't know what it is....I know it sounds stupid but i'm stumped, does anyone know how to get this baby off? Thanks!
Link Posted: 6/10/2003 4:09:46 PM EST
I tried the 7/64 allen wrench along with others but they didn't seem to work.....here is a pic. [img]http://realmoftherings.f2o.org/brandon/ar15.jpg[/img]
Link Posted: 6/10/2003 4:18:33 PM EST
Torx?? or other similar design or stripped out hex screw. Can you get in there with needle nose vice grips maybe?
Link Posted: 6/10/2003 4:21:40 PM EST
Thats a allen head screw for sure . I have the same weapon . Mine took a 7/32 allen wrench. It's on there pretty tight .
Link Posted: 6/10/2003 4:22:28 PM EST
Torx...best thing since sliced bread.
Link Posted: 6/10/2003 4:27:06 PM EST
Use 3/16" hex wrench. Eklind, with a t-handle, sold at ACE is great for this.
Link Posted: 6/10/2003 4:39:58 PM EST
It's just an A2 grip, about $4, cut it down to where you can get better access to the screw.
Link Posted: 6/10/2003 4:47:25 PM EST
You DO have a point there. Looks like the head is toast anyway. Bob
Link Posted: 6/10/2003 5:45:58 PM EST
You could try a metric wrench in a similar size. Not sure what the size would be. I've also seen guys use a screw driver.
Link Posted: 6/10/2003 5:58:31 PM EST
Thank you notack for the idea to cut off the A2 grip it worked great. :) It ended up taking a 3/16" hex wrench, thanks Lazyshooter. Thank you everyone for your help, this Hogue grip is GREAT! I didn't really think a new grip would make such a difference, but damn what a great improvement. It feels awesome!
Link Posted: 6/10/2003 5:58:44 PM EST
Lazyshooter has it right. It's a 1/4-28 X 1" long socket head cap screw. Use a 3/16" hex key (aka Allen wrench) to remove it. NOT 7/64", NOT 7/32". Not a Torx, Not a flat-bladed screwdriver. No big whoop, pretty simple stuff...
Link Posted: 6/11/2003 1:29:17 PM EST
After you remove the grip, make sure you don't lose the detent and detent spring. They fit in the small hole on the grip and fit into the receiver to secure the safety switch. Not that I have ever lost one of these. [banghead]
Link Posted: 6/13/2003 10:29:35 AM EST
Careful not to lose the small spring that fits down in the body of the grip.
Top Top