Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 11/20/2012 11:14:04 AM EST
[Last Edit: 11/20/2012 11:18:45 AM EST by Digitalpunk]
I just installed some KNS pins on a RRA lower and they stick out pretty good. I end up with one bar against the receiver and the other hovering out a bit. I thought maybe my receiver was out of spec, but I threw in some regular pins and they all fit flush.

Link Posted: 11/20/2012 11:22:44 AM EST
Normal.
Link Posted: 11/20/2012 11:22:55 AM EST
yes, it has tolerance for all receivers
Link Posted: 11/20/2012 11:50:44 AM EST
Originally Posted By TaylorWSO:
yes, it has tolerance for all receivers


I think we as a society could all learn a lot from example these pins have shown.


Link Posted: 11/20/2012 2:11:26 PM EST
Originally Posted By Digitalpunk:
I just installed some KNS pins on a RRA lower and they stick out pretty good. I end up with one bar against the receiver and the other hovering out a bit. I thought maybe my receiver was out of spec, but I threw in some regular pins and they all fit flush.

http://i605.photobucket.com/albums/tt131/TheAstroZombie84/IMAG1171.jpg


Just push in on the side where the pins stick out just enough to center them in the lower receiver. I always thought the reason for this is for a rag to get in between the pins and the receiver during cleaning.

Top Top