Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/4/2005 4:33:21 AM EDT
[Last Edit: 9/4/2005 5:35:31 AM EDT by WSAR15]
I built an upper for the first time this weekend.
The gas block (on piece low profile YTM) was tight - it could not slide onto the barrel (even with a little grease). I had to tap it on with a small hammer. The stainless barrel now looks "scratched" because of the block rubbing. I this tightness normal, or should it just slide on by hand?
Thanks
Link Posted: 9/4/2005 5:09:45 AM EDT
Link Posted: 9/4/2005 3:46:36 PM EDT
Top Top