Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 1/5/2012 5:16:51 PM EST






What did I do wrong? It has been many years since I installed an AR trigger, did I do something stupid?
Link Posted: 1/5/2012 5:32:00 PM EST
Did you read the instructions?
Link Posted: 1/5/2012 5:36:30 PM EST
I checked mine and mine doesn't rotate. Is your lower old and well used? I suppose the holed would eventually wear out. You might want to call Geissele and see what they have to say.

Good luck.
Link Posted: 1/5/2012 5:40:11 PM EST
[Last Edit: 1/5/2012 5:43:33 PM EST by MTNmyMag]
Lower has a few trigger pulls on it, the Stock Trigger I just took out was not rotating.
Link Posted: 1/5/2012 6:04:08 PM EST
[Last Edit: 1/5/2012 6:05:40 PM EST by KILLERB6]
Talk to Geissele Tech Support (for peace of mind): they will tell you it's normal (assuming spring installed correctly; I can't view pix).
Link Posted: 1/5/2012 10:07:29 PM EST
Mine does the same thing yous does.

But its hard to notice that cause I try and look through the sights when I yank the trigger
Link Posted: 1/6/2012 1:55:33 AM EST
Link Posted: 1/6/2012 2:57:19 AM EST
[Last Edit: 1/6/2012 3:07:36 AM EST by Willz]
Link Posted: 1/6/2012 5:00:16 PM EST
Pins rotate, so what?
Link Posted: 1/6/2012 5:41:36 PM EST
some people worry about the rotating pins wearing out the receivers or having slop in the action.

I use some light duty loctite and carefully put a small drop on each end of the pin at the receivers. No rotating pins now. Just make sure that you don't put enough loctite to drip into the hammer and trigger.
Link Posted: 1/7/2012 8:06:05 AM EST


This.

The KNSs were made to prevent the pins from walking out, which 99.9% of the time is due to the hammer spring being installed upside down.

If the man who makes the trigger says not to use them, I wouldn't use them.
Link Posted: 1/7/2012 8:34:29 AM EST
Originally Posted By KILLERB6:


This.

The KNSs were made to prevent the pins from walking out, which 99.9% of the time is due to the hammer spring being installed upside down.

If the man who makes the trigger says not to use them, I wouldn't use them.


I am not going to worry about it
Top Top