Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/2/2006 3:31:19 PM EST
First of all, I would like to thank you all for all the valuable information on this site. I've used it to build my first AR-15. So I feel I owe you guys this.

The instructions for my Jewel Trigger required dry firing a bunch of times to get the trigger set up. They tell you to protect the receiver from the blow of the hammer, but don't really tell you how. So, I got my dial calipers out, made a sketch, and took it into work. I found a chunk of plastic in a scrap hopper that was almost perfect size, so that’s what I used. But I'm sure you can use anything, aluminum, steel, wood. Anyway, this is what I made:

First I drew these dimentions on the side of the plastic, and cut it out with a bandsaw.

Then I put it in a vertical milling machine to cut the thickness and the slot (in black) for the bolt catch.

Here it is installed in my lower. It works pretty slick.

I know not every one has access to a milling machine, so I would recomend looking for something that is aready .875" (7/8") thick. Then you can use a grinder to put the bolt catch groove in, which doesn't take much. I hope this helps someone out. I think its perfect. I carry it in my case for any trigger set up I might encounter at the range. Happy Shootin!
Link Posted: 3/2/2006 3:59:40 PM EST
good post. i made my first one after breaking my bolt catch. i wish i made mine longer like yours so i could clamp it on the bottom in a vise.
Link Posted: 3/2/2006 4:00:57 PM EST
bump for a good thread!
Link Posted: 3/5/2006 1:42:36 AM EST
DO i hear dollar signs???? LOL
Top Top