Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 9/23/2004 10:28:59 PM EDT
I have a set of Bushmaster M4 handguards, and I was able to pry out the head shield without damaging it. I did this so I could install a GG&G rail on the underside of the handguard. Now I can't figger out how to get the darn thing back in. Is there a trick to putting a heat shield in the handguard?

Thanks in advance
Link Posted: 9/23/2004 11:03:21 PM EDT

Originally Posted By Bishop223:
Is there a trick to putting a heat shield in the handguard?



the way you pulled them out?
Link Posted: 9/23/2004 11:30:57 PM EDT
I used a screwdriver to get them out, i put the blade inbetween the handguard and shield and turned it to pop them out. Unfortunately, doesn't work both ways. I can slip one side of the shield back in, but can't press the other side far enough down to slip it into place.
Link Posted: 9/23/2004 11:34:45 PM EDT
maybe it won't fit anymore with the rail in place. that's my guess
Top Top