Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 1/21/2006 2:14:31 PM EDT
Anybody know? It does not matter if it gets destroyed, I won't need it anymore. Thanx.
Link Posted: 1/21/2006 2:24:51 PM EDT
Generally, it's pretty easy if you make sure to push them the right direction. YMMV.
Link Posted: 1/21/2006 4:16:37 PM EDT
Take a 3/32" nail set and a decent hammer (say 16-ounce or so) to drive the taper pins out. They'll drive out left to right, which is the same direction that the takedown pins pull out. Support the front sight base on either a board, or place a 4mm socket directly under each pin as you drive them out. The pins will go right into the socket.
Link Posted: 1/21/2006 4:31:36 PM EDT
If you plan on removing sight post a lot the Brownells Bench Block is a great tool to have.
Link Posted: 1/21/2006 4:39:55 PM EDT
Link Posted: 1/21/2006 5:56:45 PM EDT
Thanx, I knew I could count on you guys.
Top Top